2000 AUDI TT 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 BLU OR RED/BL (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/YEL (-) BOTH KICK PANELS FOR EACH DOOR
FrontLeftDoorTrigger BRN/YEL - BRN 10 PIN CONNECTOR, DKP
FrontRightDoorTrigger BRN/WHT - BRN 10 PIN CONNECTOR, DKP
TrunkTrigger WHT/YEL - (-) TRUNK PIN SWITCH
HoodTrigger BRN/RED - HOOD PIN SWITCH
FactoryAlarmDisarm DISARMS WITH UNLOCK WIRE
FactoryAlarmArm ARMS WITH LOCK WIRE
ParkingLights GRY/BRN GRY (+) HEADLIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Accessory01 YEL/RED + (+) IGNITION SWITCH HARNESS
Starter01 BLU OR RED/BL (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
Tach GRN/BRN (-) ECM HOUS, ORG 10 PIN OR INST. CLSTR GRN
SpeedSense BLU/WHT (AC) RADIO
ParkingLights GRY/BRN GRY (+) HEADLIGHT SWITCH
BrakeLights BLK/RED + (+) BRAKE SWITCH
Horn BLK/YEL + AT HORN
Doorlocks / Window
PowerUnLock BLU/WHT - (-) DRIVERS KICK PANEL
PowerLock GRN/WHT - (-) DRIVERS KICK PANEL
LeftFrontWindow02 NOT RECOMMENDED
RightFrontWindow01 NOT RECOMMENDED
RightFrontWindow02 NOT RECOMMENDED
Convenience
HeadLights YEL/GRN + HEADLIGHT SWITCH
LowSpeedWipers VIO/GRN GRN WIPER MOTOR
TrunkRelease VIO/GRN REV (-) TRUNK REALEASE SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 YEL/RED + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRY/BLU + (+) RADIO HARNESS
PowerAntenna RED/BRN (+) RADIO HARNESS
FrontLeftSpeakerPos RED/WHT
FrontLeftSpeakerNeg BRN
FrontRightSpeakerPos RED/WHT
FrontRightSpeakerNeg BROWN
RearLeftSpeakerPos RED/WHT
RearLeftSpeakerNeg BRN
RearRightSpeakerPos RED/WHT
RearRightSpeakerNeg BRN
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
